Configuring the Altitude AP
Summit WM User Guide, Software Version 5.3104
4 Click the 802.11a/n tab, and then do the following:
z In the Radio Mode drop-down list, click the a/n option.
z In the Channel Width drop-down list, click 40MHz.
z In the Guard Interval drop-down list, click Short.
z If only 802.11n devices are present, 11n protection and 40MHz protection must be disabled:
z Protection Mode - Click Disabled.
z 40MHz Protection Mode - Click None.
NOTE
Do not disable 802.11n protection mode if you have 802.11b client devices using this Altitude AP; instead,
configure only the 5GHz radio for high throughput unless it is acceptable to achieve less than maximum
802.11n throughput on the 2.4GHz radio.
z Aggregate MSDUs - Click Enabled.
z Aggregate MSDU Max Length - Type 4096.
z Aggregate MPDU - Click Enabled.
z Aggregate MPDU Max Length - Click Enabled.
z Agg. MPDU Max # of Sub-frames - Type 64.
z ADDBA Support - Click Enabled.
5 From the main menu, click WM Access Domain. The WM Access Domain Configuration page is
displayed.
6 In the left pane WM Access Domains list, click the WM-AD you want to configure. The Topology
tab is displayed.
To Next Page
Loading...
