Extreme Networks Summit WM - Working with third-party APs; Setting up third-party APs; Step 1 - Define a data port as a third party AP port

Summit WM User Guide, Software Version 5.3 259
8 Working with third-party APs
You can set up the Summit WM Controller to handle wireless device traffic from third-party access
points, providing the same policy and network access control. This process requires the following steps:
z Step 1 - Define a data port as a third party AP port
z Step 2 - Define a WM-AD for the third-party AP port
z Step 3 - Define authentication by Captive Portal and RAD policy for the third-party AP WM-AD
z Step 4 - Define filtering rules for the third-party APs
CAUTION
The Outdoor AP is not a third party AP. The Outdoor AP is fully managed by the Summit WM controller just like an
Altitude AP.
Setting up third-party APs
Step 1 - Define a data port as a third party AP port
1 From the main menu, click Summit Controller Configuration. The Summit Controller
Configuration page is displayed.
2 From the left pane, click IP Address. The Management Port Settings and Interfaces page is
displayed.