Summit WM User Guide, Software Version 5.3 371
Configuring filters
To configure the filters:
1 From the main menu, click WM Access Domain Configuration. The WM Access Domain
Configuration screen is displayed.
2 On the WM Access Domain Configuration screen, click the Filtering tab. The filtering rule for the
Default filter is displayed in the centre pane.
3 Type the IP address of SVP server in IP/Subnet:port box.
4 From the Protocol drop-down menu, select UDP.
5 Click Add. The new filtering rule for the SVP server is displayed in the centre pane.
6 Click Up. The filtering rule for the SVP server moves up, before the filter rule for Default filter.
7 Type the IP address of SpectraLink Gateway in IP/Subnet:port box, and then repeat steps 4 to 6.
8 Add the filtering rules for the IP addresses of all network elements as explained in steps 3 to 6.
NOTE
You must ensure that all the filtering rules, including the ones for SVP/Gateway and other network elements, are
moved up, before the filtering rule for the Default filter.
9 Select the Allow option of the Default filter.
To Next Page
Loading...
