Summit WM User Guide, Software Version 5.3 31
Step 7 - Confirming the AP firmware version
Confirm the latest firmware version is loaded. For more information, see "Performing Altitude AP
software maintenance" on page 137.
Performing the first time setup of the Summit WM
Controller
Before you can connect the Summit WM Controller to the enterprise network, you must change the IP
address of the Summit WM Controller management port from its factory default to the IP address
suitable for your enterprise network. Access the Summit WM Controller by one of two methods:
z Use a device supporting VT100 emulation, attached to the DB9 serial port (COM1 port) of the
Summit WM Controller via a cross-over (null modem) cable. Use the Command Line Interface (CLI)
commands. For more information, see the Summit WM CLI Reference Guide.
z Use a laptop computer with a Web browser. Connect the supplied cross-over Ethernet cable between
the laptop and management Ethernet port of the Summit WM Controller. Follow the steps below.
Accessing the Summit WM Controller
1 Statically assign an unused IP address in the 192.168.10.0/24 subnet for the Ethernet port of the
computer. For example, 192.168.10.205.
2 Launch your Web browser (Internet Explorer version 6.0 or higher, or FireFox).
To Next Page
Loading...
