Extreme Networks Summit WM - Modifying an Altitude APs properties

Configuring the Altitude AP
Summit WM User Guide, Software Version 5.386
4 Click the appropriate Perform action on selected Altitude APs option:
z Approved - Change an Altitude AP's status from Pending to Approved, if the WAP Registration
page was set to register only approved Altitude APs.
z Pending - AP is removed from the Active list, and is forced into discovery.
z Release - Release foreign Altitude APs after recovery from a failover. Releasing an AP
corresponds to the Availability functionality. For more information, see Chapter 6, "Availability
and session availability."
z Delete - Releases the Altitude AP from the Summit WM Controller and deletes the Altitude AP's
entry in the Summit WM Controller's management database.
Modifying an Altitude AP's properties
Once an Altitude AP has successfully registered, you can then modify its properties. Modifying an AP's
properties can include modifying properties on the following tabs:
z AP properties
z 802.11b/g/n
z 802.11a/n
z Static Configuration
z 802.1X