Configuring the Summit WM Controller
Summit WM User Guide, Software Version 5.328
System configuration overview
The following section provides a high-level overview of the steps involved in the initial configuration of
your system:
Step 1 - Before you begin configuration
Research the type of WLAN deployment that is required.
Step 2 - Preparing the network
Ensure relevant DHCP servers and RADIUS servers (if applicable) are available and configured.
WM20 z Two Data ports (10/100/1000 BaseT)
z One Management port (10/100 BaseT)
z One USB Control (console) port
z One USB Server port (future use)
z Built-in PSU, Hard Drive, Fans and Controller card - not field replaceable
z Supporting up to 32 APs
WM200 z Four Data ports (10/100/1000 BaseT)
z One Management port (10/100 BaseT)
z One Console port (DB9 serial)
z Redundant and Field Replaceable Power modules
z Redundant and Field Replaceable Fan modules
z Field Replaceable Supervisory module
z Field Replaceable Network Processor module
z Field Replaceable Flash drive module
z Support up to 100 APs
WM2000 z Four Data ports (10/100/1000 BaseT)
z One Management port (10/100 BaseT)
z One Console port (DB9 serial)
z Redundant and Field Replaceable Power modules
z Redundant and Field Replaceable Fan Modules
z Field Replaceable Supervisory module
z Field Replaceable Network Processor module
z Field Replaceable Flash drive module
z Support up to 200 APs
Table 1: Summit WM Controller product families (Continued)
Summit WM Controller Model
Number
Specifications
To Next Page
Loading...
