Summit WM Controller's physical description
Summit WM User Guide, Software Version 5.3330
Summit WM100 Controller data port cabling specification
The Summit WM100 Controller data ports have copper connectors.
NOTE
If your infrastructure does not allow the copper connection, you must get a Gigabit Media Converter to convert the
copper connection to a fibre optic connection. For example, you can use Netgear GC102 converter that receives the
copper connection and outputs traffic via the fibre optic connector.
This appendix describes the physical description and LEDs, SSD codes and their description of the
following models of the Summit WM Controller:
z Summit WM Controller WM200/2000
z Summit WM Controller WM20
Summit WM200/2000 Controller front panel
The Summit WM200/2000 Controller is composed of the following three cards:
z Media/Persistent Storage Card
z Network Processor Card
z Host Summit WM Controller Card
The following figure identifies the main components on the front panel of Summit WM200/2000
Controller.
Figure 27: Summit WM200/2000 Controller front panel
Reset
switch
Console
port
Management
port
Media/Persistent
storage card
Network Processor
card
Host Controller
card
LED
lights
Data
ports
LCT switch
Compact
Flash slot
To Next Page
Loading...
