Extreme Networks Summit WM - Adding and Registering an Altitude AP Manually

Summit WM User Guide, Software Version 5.3 83
Altitude AP
The Altitude AP can be connected and powered in the following ways:
z Power over Ethernet (802.3af):
z PoE enabled switch port
z PoE Injector
z Power by AC adaptor
Outdoor AP
The Outdoor AP can be connected and powered in the following ways:
z Power over Ethernet
z PoE enabled switch port
z Power by 48VDC (Direct Current)
z 110-230 VAC (Alternating Current)
For more information, see the Outdoor AP Installation Guide.
Altitude 802.11n AP
The Altitude 802.11n can be connected and powered in the following ways:
z Power over Ethernet
z PoE enabled switch port
z PoE Injector
NOTE
You should use a 1GB PoE injector to ensure optimum performance of the Altitude 802.11n AP.
z Power by AC adaptor
Adding and registering an Altitude AP manually
An alternative to the automatic discovery and registration process of the Altitude AP is to manually
add and register an Altitude AP to the Summit WM Controller. The Altitude AP is added with default
settings. For more information, see "Configuring Altitude AP settings" on page 84.