Configuring the Altitude AP
Summit WM User Guide, Software Version 5.382
To define the discovery process parameters:
1 From the main menu, click Altitude AP Configuration. The Altitude APs page is displayed.
2 In the left pane, click WAP Registration. The WAP Registration page is displayed.
3 In the Security Mode section, select one of the following:
z Allow all Altitude APs to connect
z Allow only approved Altitude APs to connect
The Allow all Altitude APs to connect option is selected by default. For more information, see
"Security mode" on page 81.
4 In the Discovery Timers section, type the discovery timer values in the following boxes:
z Number of retries
z Delay between retries
The number of retries is limited to 255 in a five minutes discovery period. The default number of
retries is 3, and the default delay between retries is 1 second.
5 To save your changes, click Save.
Once the discovery parameters are defined, you can connect the Altitude AP to a power source.
Connecting the Altitude AP to a power source and initiating the
discovery and registration process
When an Altitude AP is powered on, it automatically begins the discovery and registration process with
the Summit WM Controller.
To Next Page
Loading...
