Summit WM User Guide, Software Version 5.3 273
10 Working with reports and displays
This chapter describes the various reports and displays available in the Summit WM Controller, Access
Points, and WM software system, including:
z "Viewing the displays" on page 273
z "Viewing reports" on page 285
z "Call Detail Records (CDRs)" on page 288
Viewing the displays
The following displays are available in the Summit WM Controller, Access Points, and WM software
system:
z Active Altitude APs
z Active Clients by Altitude AP
z Active Clients by WM-AD
z Port & WM-AD Filter Statistics
z WM-AD Interface Statistics
z Summit Controller Port Statistics
z Altitude AP Availability
z Dynamic Authorization Statistics
z Wired Ethernet Statistics by Altitude AP
z Wireless Statistics by Altitude AP
z WDS WM-AD Altitude AP Statistics
z Admission Control Statistics by Altitude AP
z System Information
z Manufacturing Information
z Client Location in Mobility Zone
z Mobility Tunnel Matrix
NOTE
The Client Location in Mobility Zone and Mobility Tunnel Matrix displays only appear if the mobility manager function
has been enabled for the controller.
To Next Page
Loading...
