Extreme Networks Summit WM - Setting up Static Routes

Summit WM User Guide, Software Version 5.3 43
4 In the Internal VLAN ID box, type the internal VLAN ID.
5 From the Multicast Support drop-down list, click the port: esa0, esa1, esa2 and esa3esa0 or esa1.
6 To save your changes, click Save.
Setting up static routes
It is recommended that you define a default route to your enterprise network, either with a static route
or by using OSPF protocol. A default route enables the Summit WM Controller to forward packets to
destinations that do not match a more specific route definition.
To set a static route on the Summit WM Controller:
1 From the main menu, click Summit Controller Configuration. The Summit Controller
Configuration page is displayed.
2 In the left pane, click Routing Protocols. The Static Routes tab is displayed.