Extreme Networks Summit WM - Step 2 - Define a WM-AD for the third-party AP port

Working with third-party APs
Summit WM User Guide, Software Version 5.3260
3 Click the port, and in the Function box, click 3rd-party AP from the drop-down list. Make sure that
Management Traffic and SLP are disabled for this port.
4 Connect the third-party access point to this port, via a switch.
Step 2 - Define a WM-AD for the third-party AP port
1 From the main menu, click WM Access Domain Configuration. The WM Access Domain
Configuration page is displayed.
2 In the left pane, type a name that will identify the new WM-AD in the Add subnet box, and then
click Add subnet. The name is displayed in the WM Access Domains list. The To po lo g y tab is
displayed.
3 In the Assignment by drop-down list, click SSID.
4 To define a WM-AD for a third-party AP, select the Use 3rd Party AP checkbox.
5 Continue configuring your WM-AD, as described in "Configuring topology for a WM-AD for
Captive Portal" on page 157.
NOTE
Bridge Traffic at AP and MAC-based authentication are not available for third-party WM-ADs.