Configuring the Altitude AP
Summit WM User Guide, Software Version 5.3126
3 Modify the following Altitude AP default settings as required:
z Static Configuration
z WM-AD Assignments
z WAP Properties
z Radio Settings
4 To configure common configuration applicable to all Altitude APs, click the Common Configuration
tab.
5 In the Static Configuration section, do one of the following:
z To allow each Altitude AP to provide its own WM Search List, select the Learn WM Search List
from AP checkbox.
z To specify a common WM Search List for all Altitude APs, clear the Learn WM Search List from
AP checkbox, and then do the following:
a In the Add box, type the IP address of the Summit WM Controller that will control this Altitude
AP.
b Click Add. The IP address is added to the list.
c Repeat steps a and b to add additional Summit WM Controllers.
d Click Up and Down to modify the order of the Summit WM Controllers. The maximum is three
controllers.
The Altitude AP attempts to connect to the IP addresses in the order in which they are listed. The
Altitude AP is successful when it finds a Summit WM Controller that will allow it to register.
This feature allows the Altitude AP to bypass the discovery process. If the Summit Controller
Search List box
is not populated, the Altitude AP will use SLP to discover a Summit WM
Controller.
To Next Page
Loading...
