Configuring the Altitude AP
Summit WM User Guide, Software Version 5.3136
To configure Altitude APs simultaneously:
1 From the main menu, click Altitude AP Configuration. The Altitude APs page is displayed.
2 In the left pane, click WAP Multi-edit.
3 Do the following:
z In the Hardware Types list, click one or more hardware types.
z In the Altitude APs list, click one or more Altitude APs to edit. To click multiple Altitude APs,
click the APs from the list while pressing the CTRL key.
NOTE
When using multi-edit configuration, any box or option that is not explicitly modified will not be changed by the
update.
The Altitude APs shown in the Altitude APs list can be from any version of the software. Attributes that are
common between software versions are set on all Altitude APs. Attributes that are not common, are only sent to
the AP versions to which the attributes apply. Attempting to set an attribute that does not apply for an AP will
not abort the multi-edit operation.
4 Modify the configuration of the selected Altitude APs:
z WAP Properties - For more information, see "Modifying an Altitude AP's properties" on page 86.
z Radio Settings - For more information, see "Modifying Altitude AP radio properties" on page 88.
z Static Configuration - For more information, see "Setting up the Altitude AP using static
configuration" on page 114.
5 In the WAP Properties, Radio Settings, and Static Configuration sections of the page, select and
type the attributes you want to edit for all selected APs.
To Next Page
Loading...
