WM Access Domain Services configuration
Summit WM User Guide, Software Version 5.3192
NOTE
Before enabling multicast filters and depending on the topology of the WM-AD, you may need to define which
physical interface to use for multicast relay. Define the multicast port on the IP Addresses page. For more
information, see "Setting up the data ports" on page 36.
To enable multicast for a WM-AD:
1 From the main menu, click WM Access Domain Configuration. The WM Access Domain
Configuration page is displayed.
2 In the left pane WM Access Domains list, click the WM-AD you want to enable Multicast for. The
Top ology tab is displayed.
3 Click the Multicast tab.
4 To enable the multicast function, select Enable Multicast Support.
5 Define the multicast groups by selecting one of the radio buttons:
z IP Group - Type the IP address range.
z Defined groups - Click from the drop-down list.
6 Click Add. The group is added to the list above.
7 To enable the wireless multicast replication for this group, select the corresponding Wireless
Replication checkbox.
8 To modify the priority of the multicast groups, click the group row, and then click the Up or Down
buttons.
To Next Page
Loading...
