Working with the Summit WM series Spy
Summit WM User Guide, Software Version 5.3266
To run the Summit WM series Spy scan task mechanism:
1 From the main menu, click Summit Spy. The Summit Spy page is displayed.
2 Click the Scan Groups tab.
3 In the Scan Group Name box, type a unique name for this scan group.
4 In the Altitude APs list, select the checkbox corresponding to the Wireless APs you want included in
the new scan group, which will perform the scan function.
NOTE
A Wireless AP can participate in only one Scan Group at a time. It is recommended that the Scan Groups
represent geographical groupings of Wireless APs.
5 In the Radio drop-down list, click one of the following:
z Both - The 11a and 11b/g radios both perform the scan function.
z 11a - Only the 11a radio performs the scan function.
z 11b/g - Only the 11b/g radio performs the scan function.
6 In the Channel List drop-down list, click one of the following:
z All - Scanning is performed on all channels.
z Current - Scanning is performed on only the current channel.
7 In the Scan Type drop-down list, click one of the following:
z Active - The Wireless AP sends out ProbeRequests and waits for ProbeResponse messages from
any access points.
To Next Page
Loading...
