Working with reports and displays
Summit WM User Guide, Software Version 5.3284
z Yellow - The mobility manager is in communication with an agent but the data tunnel is not yet
successfully established.
z Red - The mobility manager is not in communication with an agent and there is no data tunnel.
Client Location in Mobility Zone
You can do the following:
z Sort this display by home or foreign controller
z Search for a client by MAC address, user name, or IP address, and typing the search criteria in the
box
z Define the refresh rates for this display
z Export this information as an xml file
Mobility Tunnel Matrix
z Provides connectivity matrix of mobility state
z Provides a view of:
z Tunnel state
z If a tunnel between controllers is reported down, it is highlighted in red
z If only a control tunnel is present, it is highlighted in yellow
z If data and control tunnels are fully established, it is highlighted in green
z Tunnel Uptime
z Number of clients roamed (Mobility loading)
z Local controller loading
z Mobility membership list
A Summit WM Controller is only removed from the mobility matrix if it is explicitly removed by the
administrator from the Mobility permission list. If a particular link between controllers, or the controller
is down, the corresponding matrix connections are identified in red color to identify the link.
The Active Clients by WM-AD report for the controller on which the user is home (home controller)
will display the known user characteristics (IP, statistics, etc.). On the foreign controller, the Clients by
WM-AD report does not show users that have roamed from other controllers, since the users remain
associated with the home controller's WM-AD.
The Active Clients by AP report on each controller will show both the loading of local and foreign users
(users roamed from other controllers) that are taking resources on the AP.
NOTE
Although you can set the page refresh period less than 30 seconds, the page will not be refreshed quicker than 30
seconds. The page will be refreshed according to the value you set only if you set the value above 30 seconds.
To Next Page
Loading...
