Working with reports and displays
Summit WM User Guide, Software Version 5.3286
NOTE
If you open only automatically refreshed reports, the Web management session timer will not be updated or reset.
Your session will eventually timeout.
The following is an example of the AP Inventory report:
The following is a description of the column names and abbreviations found in the AP Inventory
report:
z Rdo - Radio
z Ra - 802.11a radio. The data entry for an Wireless AP indicates whether the 11a radio is on or off.
z Rb - 802.11b protocol enabled. Possible values are on or off.
z Rg - 802.11g protocol enabled. Possible values are on or off.
z Rn - 802.11n protocol enabled. Possible values are on or off.
z DP - DTIM period
z BP - Beacon Period
z SRL - Short Retry Limit
z LRL - Long Retry Limit
z RT - RTS Threshold
z FT - Fragmentation Threshold
z Ch - Channel served by the corresponding radio.
z PL - Power Level (Defined in the Wireless AP radio properties pages.)
z BR - Basic Rate (Only applies to Wireless APs running 3.1 or earlier.)
z ORS - Operational Rate Set (Only applies to Wireless APs running 3.1 or earlier.)
z MnBR - Minimum Basic Rate (For more information, see the Wireless AP radio configuration tabs.)
z MxBR - Maximum Basic Rate
z MxOR - Maximum Operational Rate
z RxDV - Receive Diversity
z TxDV - Tx Diversity
z Pmb - Preamble (long, short)
z PM - Protection Mode
z PR - Protection Rate
z PT - Protection Type
To Next Page
Loading...
