Extreme Networks Summit WM - Page 332

Summit WM Controller's physical description
Summit WM User Guide, Software Version 5.3332
NOTE
Although the Active LED will be lit Green during the firmware initialization, this LED state is irrelevant to the SSD
display or the condition. You must ignore the LED state during the firmware initialization.
Application initialization:
Warning conditions:
Green 9 The system is loading subsystem.
Green b The system is starting the operation system. The system is
active.
Table 30: LED states and SSD codes during application initialization
Active LED
Warning
LED
Error
LED SSD Code Condition
Green 0 Application initialization started.
Green C System configuration in progress
Green 1 Continuing application initialization
Green 2 Initializing Forwarding Engine
Green 3 Completing application initialization.
Green A Application initialization complete. System active.
Green H System halted. Administrator requested halting of system.
Table 31: LED states and SSD codes during warning conditions
Active LED
Warning
LED
Error
LED
SSD Code Condition
Green Yellow 1 High temperature reached.
Green Yellow 2 Fan unit failure. Rotation counter indicates zero speed for
one of the lateral trays. May be the result of fan tray
removal.
Green Yellow 3 Power supply failure. Failed to detect one of the power
supplies. May be the result of the fan tray removal of one of
the power supplies.
Green Yellow 4 FDD low sector count (40 backup sectors remaining).
Green Yellow 5 FDD extremely low sector count (20 backup sectors
remaining)
Table 29: LED states and SSD codes during firmware initialization (Continued)
Active LED
Warning
LED
Error
LED
SSD
Codes
Condition