Extreme Networks Summit WM - Page 352

Regulatory information
Summit WM User Guide, Software Version 5.3352
NOTE
The qualification testing and results are based on above described antennas, cable types, lengths, and connector
types. Other cable lengths and connector types are also available which are specified by the suffix part of the part
numbers (ex. SR2405135Dxxx, where the xxx suffix represents cable length and/or connector type). The antenna
feedline used in testing are the minimum cable length. Longer cable may be used with losses greater than or equal
to the cables used for testing. The maximum power settings must be adjusted according to Table 42 and Table 43.
NOTE
If one of the above antennas is used, you must select an operating channel (on the Altitude APs configuration pages)
and the corresponding allowed max power from the values listed in Table 42 and Table 43. DO NOT select a higher
power than the value listed in Table 42 and Table 43.
#2 S24493TS indoor omni, 3
inputs
3 2400-
2500
4900-
5990
3 feet /
19AWG
CMP(ETL)
C(ETL)
9700851
RPSMA,
3ea.
1
#3 SL24513WP indoor omni 3 2400-
2500
5150-
5850
3 feet /
19AWG
CMP(ETL)
C(ETL)
9700851
RPSMA 3
#4 S24497Pxxx indoor 60 degree
sector
directional
7
8
2400-
2500
4900-
5990
3 feet /
19AWG
CMP(ETL)
C(ETL)
9700851
RPSMA 3
Hyperlink Tech
#5 HG2458CUx
xx
indoor omni 3 2300-
2600
4900-
6000
1 foot /
20AWG
Coleman
Cable
921021
N-female 3
Maxrad
#6 MDO24005P
Txxx
indoor omni, 2
inputs
5.2 2400-
2485
3 feet /
19AWG
CMP(ETL)
C(ETL)
9700851
RPSMA,
2ea.
1
Table 41: List of IC approved antennas - Altitude 451 (Continued)
# Model Application Shape
Gain
(dBi)
Frequency
(MHz)
Coax Cable
Length/Type
Connector
Type
Total #
required
antennas