Summit WM User Guide, Software Version 5.3 55
8 In the User ID and the Password boxes, type the user's ID and the password, which were configured
on the RADIUS Server, and then click Te st. The RADIUS connectivity result is displayed.
NOTE
To learn how to configure the User ID and the Password on the RADIUS Server, refer to your RADIUS Server's
user guide.
NOTE
After configuring the RADIUS-based login authentication mode, you must always test the connectivity to RADIUS
Server as explained in Step 6 and 7. If you do not test the RADIUS Server connectivity, and you have made some
error in configuring the RADIUS-based login authentication mode, you will be locked out of the Summit WM
Controller.
To Next Page
Loading...
