Extreme Networks VSP 4900 Series User Manual

To replace the fan module in a switch, do the following.
1. Gently pull the tab (labeled Air Out) on the end of the fan module.
The fan module is held in place by spring clips. As you pull, the clips will disenagage
and the fan will stop.
2. Slide the fan module out of the switch and set it aside.
3. Verify that the airow direction on the replacement fan module matches that of the
installed fan modules.
Fans with front-to-back airow have red tabs and are labeled Air Out.
4. Carefully slide the replacement fan module into the switch.
Push until the fan module snaps into place. The fan will automatically start to
operate.
Removing and Replacing Components Replace Fan Modules
VSP 4900 Series Switches: Hardware Installation Guide 69

Extreme Networks VSP 4900 Series Specifications

General

Brand	Extreme Networks
Model	VSP 4900 Series
Category	Switch
Language	English