Extreme Networks VSP 4900 Series User Manual

Power cords used with AC-powered switches or AC power supplies must meet the
following requirements:
• The power cord must be agency-certied for the country of use.
• The power cord must have an IEC320-C15 connector for connection to the switch or
power supply.
• The power cord must have an appropriately rated and approved wall plug applicable
to the country of installation.
• For cords up to 14.76 feet (4.5 m) long, the wire size must be 15 AWG (2 mm
2
)
minimum wire length up to 4.9 feet (1.5 m).
The power cords for switches that use either the 1100 W or 715 W power supplies are
keyed with a “notch” to ensure the proper orientation when plugged in. These cords
are of 3x14 AWG.
For details about obtaining AC power cords for use in your country, refer to http://
www.extremenetworks.com/product/powercords/.
Power Cord Requirements for AC-Powered Switches
and AC Power Supplies Technical Specications
88 VSP 4900 Series Switches: Hardware Installation Guide

Extreme Networks VSP 4900 Series Specifications

General

Brand	Extreme Networks
Model	VSP 4900 Series
Category	Switch
Language	English