Extron electronics DXP 44 HD 4K PLUS - Page 69

DXP HD 4K PLUS Series • SIS Configuration and Control 61
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
IP Control Port Commands (continued)
Device Name
Set device name
24
EX3^CN} Ipn
•
X3^]
Set the device name.
NOTES:
• The first character must be a letter. The last character must not be a hyphen. No blank or space
characters are permitted. Uppercase and lowercase letters are interchangeable.
• To set the device name to the factory default, enter a space for the device name. The default name is a
combination of the model name and the last three character pairs of the MAC address.
View device name
ECN} X3^]
View the current device name.
Date and Time
Set date and time
EX3&CT} IptX3&]
Set the date and time.
View date and time
ECT} X3*]
View the date and time.
View GMT offset
ECZ} X3(]
View the GMT offset.
View available time zones
E*TZON} <Multiple X4)*X4!]>
]] occurs at the end of the list.
View a list of available time
zones.
Set time zone
EX4)*TZON} Tzon
•
X4)*X4!]
Set the time zone.
NOTE: Use the View available time zones command for available values for X4).
View time zone
ETZON} X4)*X4!]
Tzon
•
X4)*X4!]
View the set time zone.
Verbose modes 2 and 3
KEY:
X3^ = Device name
Maximum 63 alphanumeric characters or hyphens. The first character
must be alpha. The last character cannot be a hyphen. No blank or
space characters are permitted.
X3& = Date and time
In the format MM/DD/YY•HH:mm:SS
MM = month: 01 (January) to 12 (December)
DD = day: 01 to 31 (depending on the month)
YY = year: 00 to 99 (last two digits)
HH = hour: 00 to 23, mm = minute: 00 to 59, SS = second: 00 to 59
X3* = Date and time (view only)
In the format DAY,
•
DD
•
MMM
•
YYYY
•
HH:mm:SS
DAY =day of the week: Mon to Sun
DD = date: 01 to 31 (depending on the month)
MMM = month: 01 to 12
YYYY = year: 2000 to 2099
HH = hour: 00 to 23, mm = minute: 00 to 59, SS = second: 00 to 59
X3( = GMT offset
-12:00 to +14:00
X4) = Time zone
Time zone code (use the Read time zones command to determine the
available time zones). The code is followed by an * in the response.
X4! = Time zone description In the format (UTC X3()
•
<Description>. This is the UTC equivalent
for a time zone as well as a description of the geographical area.