Extron electronics DXP 44 HD 4K PLUS - Page 78

DXP HD 4K PLUS Series • SIS Configuration and Control 70
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Front Panel Lockout Mode (Executive Mode)
Set Front Panel Lockout mode
X2)X ExeX2)]
Set the accessibility to
front panel operation.
View Front Panel Lockout mode
X
X2)]
View the accessibility level
for front panel operation.
Device Commands
Verbose Mode
Set verbose mode
EX2#CV} VrbX2#]
Enable or disable
verbose mode and
tagged responses, where
additional information is
provided in response to a
query.
View verbose mode
ECV} X2#]
View the verbose mode.
Device Name
Set device name
24
EX3^CN} Ipn•X3^]
Set the DXP unit name.
NOTES:
• The first character must be a letter. The last character must not be a hyphen. No blank or space
characters are permitted. Uppercase and lowercase letters are interchangeable.
• To set the device name to the factory default, enter a space for the device name. The default name is a
combination of the model name and the last three character pairs of the MAC address.
Set device name to default
E•CN}
Ipn•DXP_42_HD_4K_PLUS
Set the DXP unit name to
DXP_42_HD_4K_PLUS
View device name
ECN} X3^]
View the current device
name.
KEY:
X2) = Front Panel Lockout mode
0 = unlock the front panel
1 = mode 1 (complete front panel lockout)
2 = mode 2 (tie configuration and preset management only,
default)
X2# = Verbose mode
0 = clear or none (default for Telnet connections)
1 = verbose mode (default for RS-232 and USB connections)
2 = tagged responses for queries
3 = verbose mode and tagged queries
See the Verbose mode command description on
page45 for more information.
X3^ = Device name
Maximum 24 alphanumeric characters or hyphens. The first
character must be alpha. The last character cannot be a
hyphen. No blank or space characters are permitted.