Extron electronics IN1804 Series - Page 85

IN1804 Seamless Scaling Switchers • SIS Configuration and Control 77
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Advanced Configuration (continued)
Resets
NOTE: The remote power state for HDBT/XTP mode is forced to Off (0). Attempts to change the power setting while the
unit is not in DTP mode result in an E14 (Not valid for current configuration) error message.
System reset (soft reset)
E
ZXXX
}
Zpx
]
Reset all device settings to factory
defaults.
Absolute system reset
E
ZQQQ
}
Zpq
]
Set all device settings plus DHCP and
the IP address to factory defaults.
DHCP = Off, IP address =
192.168.254.254.
This command also removes the
initial serial number password that is
set at the factory and resets it to no
password.
Absolute system reset, retain
IP settings
E
ZY
}
Zpy
]
Same as absolute system reset except
that IP address, subnet mask, gateway
address, DHCP, and port mapping are
not reset.
Serial Port Configuration
Set serial port parameters
EX5&
*
X5*
,
X5(
,
X6)
,
X6!
CP
}
Cpn
X5&
•Ccp
X5*
,
X5(
,
X6)
,
X6!]
Set the RS-232 port parameters
View the serial port
parameters
EX5&
CP
} X5*
,
X5(
,
X6)
,
X6!]
Verbose modes 2 and 3:
Cpn
X5&
•Ccp
X5*
,
X5(
,
X6)
,
X6!]
View port parameters
X5*
,
X5(
,
X6)
, and
X6!
of port
X5&
.
Set UART start point
EX6%
MD
}
Pmd
X6%]
Set the port number start point for the
over TP Universal asynchronous receiver-
transmitter (UART).
View UART start point
E
MD
}
X6%]
View the port number start point for the
over TP UART.
Send commands over
RS-232 insertion
E
+snds
X5&
*
X3#}
command
Snds
X5&]
Send a command of
X3#
characters from
port
X5&
to a TP endpoint.
KEY:
X3#
= Command length
Number of characters to be sent
X5&
= Remote port number
1 = Remote port (3-pole captive screw)
4 = Universal asynchronous receiver-transmitter (UART) on TP input 4
(IN1804 DI and DI/DO only)
9 = UART on TP output 1A (IN1804 DO and IN1804 DI/DO only)
X5*
= Baud rate of port
300, 600, 1200, 1800, 2400, 3600, 4800, 7200, 9600 (default),
14400, 19200, 28800, 38400, 57600, 115200
X5(
= Parity
Odd, Even, None (default), Mark, Space (only the first letter is required).
X6)
= Data bits
7 or 8 (default)
X6!
= Stop bits
1 (default) or 2
X6%
= UART port start point
Start point for UART ports:
TP IN4 =
X6%
+ 1 (IN1804 DI and IN1804 DI/DO only)
TP OUT 1A =
X6%
+ 3 (IN1804 DO and IN1804 DI/DO only)
Default = 2000