Extron electronics SSP 200 - Front Panel Features; Source Format

SSP 200 • Panel Features 11
Front Panel Features
50-60 Hz
100-240V
--A MAX
1 THRU
OUTS
DMP EXP
INPUTS
SSP 200
2
5
LR
34
1(LF) 2(RF) 3(C) 4(SUB) 5(LS) 6(RS)789 10(MIX)
RS-232
Tx Rx G
LAN
RESET
e
SSP 200
CONFIG
PCM
2-CH
ATMOS
HDCP
EXP
SURROUND SOUND PROCESSOR
SOURCE INPUT VOLUME
1 2 3 4 5
AAA
AAA CCC
BBB CCC
BBB
HHH
DDD EEE
DDD EEE FFFGGG
Figure 10. SSP200 Front Panel Features
A
Status LED
D
Input Selections
B
Configuration port
E
Volume Adjustment
C
Input Source format indicators
A
Status LED — This LED indicates the current power and boot status of the SSP 200.
B
Configuration port — The SSP200 can be configured via PCS or by using Extron
Simple Instruction Set (SIS) commands via this USB mini‑B port or via the LAN and
RS‑232 ports on the rear panel (see SIS Configuration and Control starting on
page62). In addition, this configuration port is used for firmware updates from a PC.
NOTE: The front panel configuration port, the rear panel RS‑232 port, and the rear
panel LAN port can all be used at the same time. No connection has precedence.
The SSP200 responds to commands in the order received.
Source Format
C
Input Source format indicators — The bank of eight LEDs identify the format of the
audio input (see Source Formats starting on page24).
• : Dolby source material
• DTS: DTS source material
• PCM: 2‑channel uncompressed digital source format up to 7.1 multi‑channel
NOTES:
• A digital signal that does not have a supported sampling rate or is
compressed PCM is considered an unrecognized signal and is muted.
• When a media player is paused during playback, the SSP200 may or
may not continue to receive source format information from the player.
Some players continue to send the same source format information in a
loop, allowing the SSP200 to retain the previous settings. Other players
completely disconnect the signal from the SSP200 (unlocked state) so that
the active input appears as if there is no connection present. The remainder
of players change the source output to PCM without an actual signal being
sent (digital silence). During digital silence, the PCM LED lights but the
2‑CH source LED does not.
10