Extron electronics SSP 200 - Panel Features; Rear Panel Features

SSP 200 • Panel Features 6
Panel Features
This section describes:
• Rear Panel Features
• Front Panel Features
Rear Panel Features
50-60 Hz
100-240V
--A MAX
1 THRU
OUTS
DMP EXP
INPUTS
SSP 200
2
5
LR
34
1(LF) 2(RF) 3(C) 4(SUB) 5(LS) 6(RS)789 10(MIX)
RS-232
Tx Rx G
LAN
RESET
e
SSP 200
CONFIG
PCM
2-CH
ATMOS
HDCP
EXP
SURROUND SOUND PROCESSOR
SOURCE INPUT VOLUME
1 2 3 4 5
A
A
A
A
A
A C
C
C
B
B
B C
C
C
B
B
B
H
H
H
D
D
D E
E
E
D
D
D E
E
E F
F
FG
G
G
Figure 3. SSP200 Rear Panel Features
A
AC power input
E
LAN port
B
Audio inputs
F
Reset button
C
DMP expansion port
G
Status LED
D
RS-232 port
H
Analog outputs
A
AC power input — Use an IEC power cable to connect the processor to a
100‑240VAC, 50 ‑ 60 Hz, power source.
B
Audio inputs — The SSP200 accepts four digital inputs and one analog input (see
figure4).
DTS
D
PCM
2-CH
DTS: X
ATMOS
HDCP
EXP
SOURCE
INPUT
1 2 3 4 5
VOLUME
OUTS
1(LF) 2(RF) 3(C) 4(SUB) 5(LS) 6(RS) 78 910(MIX)
RS-232
Tx Rx G
1 THRU
INPUTS
2
5
LR
34
Figure 4. SSP200 Audio Inputs
• Input 1 accepts digital signals through an HDMI cable (see Securing an HDMI
Connector on page10). The THRU connection passes the original HDMI video
signal out, unaltered, to another device. Audio passed to the THRU connection is
configurable (see Input/Output Config on page32).
• Input 2 accepts digital signals through a S/PDIF coaxial cable.
• Inputs 3 and 4 accept digital signals through S/PDIF optical (TOSLINK) cables.
3
4