Extron electronics SSP 200 - Speaker Setup; Speaker Placement

SSP 200 • Speaker Setup 18
Speaker Setup
This section provides background information about arranging speakers in a room and
the settings that can be adjusted by the Product Configuration Software (PCS). Extron
recommends that the PCS is used to make configuration changes to the SSP200 (see
Product Configuration Software starting on page29). Topics in this section include:
• Speaker Placement
• Back Speakers
• Bass Management
• Speaker Delay Settings
• Test Signals
• Output Channel Trim Settings
• Listening Mode Settings
• Equalization
Speaker Placement
The following figures show the recommended speaker placement, relative to the listener, for
some of the most common speaker configurations.
Speaker Abbreviations
Abbreviations Channel Descripton Abbreviations Channel Descripton
LF Left Front RB Right Back
RF Right Front LH Left Height
C Center RH Right Height
SUB Subwoofer (Mono) LHF Left Height Front
LS Left Surround RHF Right Height Front
RS Right Surround LHB Left Height Back
LB Left Back RHB Right Height Back
NOTE: All speakers should be angled inwards so that they face towards the listener.
0°
22°
30°
C
R
L
120°
110°
120°
110°
RB
LB
22°
30°
C
R
L
RB
LB
Figure 17. Speaker 5.1 Setup
17