Extron electronics SSP 200 - Page 25

SSP 200 • Panel Features 17
• Select Yes, now and every time I connect a device (see figure15,
2
, on
the previous page) if you want the computer to automatically connect to Windows
Update to search the web every time the processor is connected to this USB port.
• Select No, not this time (
3
) if you do not want the computer to connect to
Windows Update to search the web at this time (for example, if the driver is already
on your computer).
3. Click Next (
4
).
The next screen of the Wizard opens:
1
2
Figure 16. Installing the Software Automatically
4. Select the Install the software automatically (Recommended) radio button
(see figure16,
1
).
5. Click Next (
2
).
NOTE: You do not need to insert a disc.
The PC locates the driver needed and installs it in the correct location on the hard drive.
6. When the Completed screen appears, click Finish to close the wizard.
NOTE: The wizard opens only on the first occasion you connect the SSP 200 to
that USB port. The wizard reappears if you connect the unit to a different USB
port or if you connect a different piece of equipment, requiring a different driver, to
the same USB port.
7. Configure the processor as desired using SIS commands (see SIS Configuration
and Control starting on page62) or PCS (see Using PCS Software starting on
page30).
16