Extron electronics SSP 200 - Audio Config

SSP200 • Product Configuration Software 41
Audio Config
The Audio Configuration page has four tabs.
NOTE: The Audio Configuration tabs should be adjusted in the order they appear.
• Speaker Configuration
• Speaker Delay
• Test and Output Trim
• Speaker Equalization/Output EQ
Speaker Configuration
Click the Audio Config button (see figure26,
3
, on page31). The Audio
Configuration window opens to the Speaker Configuration panel (see figure37).
Figure 37. Speaker Configuration
The various controls can be adjusted to configure the speakers as needed.
1
Speaker Enablement — This feature determines which output speaker channels
are enabled and pass audio. There are additonal drop‑down lists for Back and Height
speakers in those positions or if a stereo downmix on the analog output is required.
2
Bass Management/Full Range — This selection is only enabled when its
corresponding speaker channel is enabled. When Bass Management is selected, only
frequencies above the crossover frequency threshold is sent to the corresponding
speaker channels. When Full Range is selected, all frequencies are sent to the
corresponding speaker channels.
3
Crossover Frequency — When Bass Management is selected for a particular
channel, the frequencies below this threshold are sent to the subwoofer channel (or
Full Range speaker channels when the subwoofer channel is disabled) and the
frequencies above this threshold are sent to the speaker channel.
37