Extron electronics SSP 200 - Network Settings

SSP 200 • Internal Web Page 83
Network Settings
The Network Settings panel shows the current network settings for the SSP 200 (see
figure63 on page81). To change the settings, click EDIT to access the Network
Settings dialog box (see figure66).
Figure 66. Network Settings Dialog Box
To configure the settings for use with DHCP:
1. Set the DHCP slider (
1
) to On.
2. Click SAVE (
5
). An IP address is automatically assigned to the device. Contact your
ITadministrator for more information.
Click CANCEL (
6
) to exit the process without making any changes.
To configure the settings with a static IP address:
1. Ensure the DHCP slider (
1
) is set to Off.
1. In the IP Address field (
2
), enter an IP address for the device.
2. In the Subnet field (
3
), enter the subnet mask for the device.
3. In the Gateway field (
4
), enter the default gateway to be used.
4. Click SAVE (
5
) to apply the changes, or click CANCEL (
6
) to exit the process without
making any changes.
NOTE: The default TCP/IP settings are:
• IP address = 192.168.254.254
• Subnet Mask = 255.255.0.0
• Default Gateway = 0.0.0.0
66