Extron electronics SSP 200 - SIS Configuration and Control; Connection Options; Port; Front Panel Configuration Port

SSP 200 • SIS Configuration and Control 62
SIS Configuration
and Control
This section describes Simple Instruction Set (SIS) command programming and control of
the SSP 200, including:
• Connection Options
• Host-to-device Communications
• Using the Command and Response Tables
• Command and Response Tables
Connection Options
The SSP 200 can be configured and controlled using SIS commands or internal web pages.
Configure and control the SSP 200 remotely via a host computer or other device (such as
a control system) by connecting to the rear panel RS‑232 port, LAN port, or the front panel
USB Config port of the SSP device.
RS-232 Port
The SSP 200 has a rear panel serial port (see figure3 on page6) that can be
connected to a host device such as a computer running the Extron DataViewer utility. The
port makes serial control of the SSP possible. Use the protocol information listed below to
make the connection (see Host-to-device Communications on page64).
RS-232 protocol defaults:
• 9600 baud • no parity • 1 stop bit
• 8 data bits • no flow control
Front Panel Configuration Port
The USB mini‑B port is located on the front panel (see figure10 on page11). Connect to
a host computer for configuration using SIScommands with DataViewer, available at
www.extron.com. To connect the SSP 200 to a host computer, download the USB driver,
follow the on‑screen instructions, and configure the SSP as required.