Extron electronics SSP 200 - Securing an HDMI Connector

SSP 200 • Panel Features 10
Securing an HDMI Connector
Follow these instructions to secure the HMDI connectors to the processor with the LockIt
HDMI lacing bracket provided:
1
Plug the HDMI cable into the processor rear
panel connection.
2
Loosen the HDMI connection mounting screw
from the panel enough to allow the LockIt lacing
bracket to be placed over it. The screw does
not have to be removed.
3
Place the LockIt lacing bracket on the screw
and against the HDMI connector, then tighten
the screw to secure the bracket.
ATTENTION:
• Do not overtighten the HDMI
connector mounting screw. The
shield it fastens to is very thin and
can easily be stripped.
• Ne serrez pas trop la vis de montage
du connecteur HDMI. Le blindage
auquel elle est attachée est très fin
et peut facilement être dénudé.
4
Loosely place the included tie wrap around the
HDMI connector and the LockIt lacing bracket
as shown.
5
While holding the connector securely against the lacing bracket, tighten the tie wrap,
then remove any excess length.
3
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5