Extron electronics SSP 200 - Firmware

SSP 200 • Internal Web Page 86
Firmware
The Firmware panel (see figure63,
8
, on page81) displays the current firmware
version and when it was last updated to the device (see figure69,
1
).
Figure 69. Firmware Panel
NOTE: The latest firmware can be downloaded from the Extron website (see
Downloading the SSP 200 Firmware on page58).
To update the SSP200 firmware version:
1. Before starting, download the latest version of the firmware to your PC (see the note
above).
2. An executable (.exe) file is downloaded to the PC. Run this program to place the
firmware on the PC for future use. Make a note of the folder where the firmware file was
saved.
ATTENTION:
• The extension of the firmware file must be .eff. Opening a file with an incorrect
extension may cause the device to stop functioning.
• L’extension du fichier firmware doit être .eff. Si un fichier est ouvert avec une
mauvaise extension, l’appareil peut arrêter de fonctionner.
3. On the Firmware panel, click Select File (see figure69,
2
). This opens an Explorer
window on your PC.
4. Browse to the location of the firmware and select the file (see figure70).
Figure 70. Selecting the Firmware File
69
70