Extron electronics SSP 200 - Volume Adjustment; Analog Input Gain Level

SSP 200 • Panel Features 13
Volume Adjustment
E
Volume control and LED bar — Use the rotary encoder to adjust the output volume
from 0%to100%. The default setting is 80%.
As the volume increases or decreases, the LED bar lights to indicate the current volume
setting (see the table below). As the volume is increased or decreased, the top LED
flashes.
If the audio is muted using PCS or SIS, the entire LED bar blinks to indicate a muted
state. The LEDs return to their previous state when the audio is unmuted.
e
CONFIG
DTS
D
PCM
2-CH
DTS: X
ATMOS
HDCP
EXP
SURROUND SOUND PROCESSOR
SOURCE INPUT
VOLUME
1 2 3 4 5
Figure 12. Volume Control and LED Bar
Volume steps for each LED LEDs lit
96% to 100% All 8 LEDs on
91% to 95% Bottom 7 LEDs on
86% to 90% Bottom 6 LEDs on
81% to 85% Bottom 5 LEDs on
71% to 80% Bottom 4 LEDs on
51% to 70% Bottom 3 LEDs on
31% to 50% Bottom 2 LEDs on
1% to 30% Bottom LED on
0% All LEDs flashing
The volume can also be controlled using SIS (see Volume on page77).
Analog Input Gain Level
Alternatively, the rotary encoder controls the gain level of the analog signal on Input 5.
Analog input gain is adjustable from ‑18 dB to +24 dB.
To adjust input gain, press and hold the Input 5 button, then turn the rotary encoder to
increase or decrease the gain level of the input signal (see figure13 on the next page).
When the Input 5 button is released, the input gain level control is deactivated. All active
(input level) LEDs in the LED array bar deactivate momentarily, and then re‑activate to
display the current volume setting.
12