Extron electronics SSP 200 - Internal Web Page; Overview of the Internal Web Page; Accessing the Internal Web Page

SSP 200 • Internal Web Page 80
Internal Web Page
This section gives an overview of the SSP 200 internal web page. Topics include:
• Overview of the Internal Web Page
• Accessing the Internal Web Page
• Web Page Components
Overview of the Internal Web Page
The SSP 200 internal web pages provide the software user interface for operating and
configuring the SSP 200 via a PC on the same network. This allows you to:
• View and edit the device name
• Set the date and time either manually or to sync with a connected PC
• View input and output details
• View and edit the network settings
• Update the firmware version
Connection is made via a LAN or WAN connection through the rear panel LAN (RJ-45) port,
using a web browser such as Microsoft
®
Edge
®
, Mozilla
®
Firefox
®
, Google Chrome
™
, or
Apple
®
Safari
®
.
Accessing the Internal Web Page
To access the internal web pages:
1. Using an RJ-45 cable, connect the device to a LAN via the rear panel LAN port (see
Rear Panel Features on page6).
2. Launch the web browser on your computer.
3. Enter the device IP address into a web browser address bar. If the IP address has not
been changed, the default address is 192.168.254.254.
4. Press the keyboard <Enter> key. The SSP200 web page requires user authentication
to continue. Click in the Password field and enter the appropriate administrator or user
password. Click OK.
NOTE: The factory configured passwords for all accounts on this device have been
set to the device serial number. Passwords are case sensitive. If the SSP 200 is
reset, the passwords revert to the default, which is extron.