Extron electronics SSP 200 - Page 15

SSP 200 • Panel Features 7
• Input 5 accepts a balanced or unbalanced, stereo or mono, analog input through
a 6‑pole captive screw connector. Figure 5 shows the correct wiring for different
analog input signals using either 3‑pole or 6‑pole connectors.
"
(5 mm) MAX. (typ)
3
16
3-pole Audio Input Wiring
Balanced Input
Sleev
e
Ring
Tip
Tip
Sleeve
Jumper
Unbalanced Input
Tip
Slee
ve
Ring
Tip
Slee
ve
Ring
Tip
Sleeve
Tip
Sleeve
6-pole Audio Input Wiring
Balanced Input Unbalanced Input
Jumper
Jumper
Figure 5. Analog Input (Input 5) Wiring
ATTENTION:
• Do not tin the wire leads before installing into the connector. Tinned wires are
not as secure in the connector and could be pulled out.
• Ne pas étamer les conducteurs avant de les insérer dans le connecteur. Les
câbles étamés ne sont pas aussi bien fixés dans le connecteur et pourraient
être tirés.
• The length of the exposed wires in the stripping process is important. The
ideal length is 3/16 inches (5 mm). Any longer and the exposed wires may
touch, causing a short circuit between them. Any shorter and the wires can be
easily pulled out even if tightly fastened by the captive screws.
• La longueur des câbles exposés est importante lorsque l’on entreprend de
les dénuder. La longueur idéale est de 5mm (3/16inches). S’ils sont
trop longs, les câbles exposés pourraient se toucher et provoquer un court‑
circuit. S’ils sont trop courts, ils peuvent être tirés facilement, même s’ils sont
correctement serrés par les borniers à vis.
C
DMP Expansion port — This proprietary Extron DMP Expansion port provides 14
output channels and 2 input channels (for use as a stereo input) for exclusive use with
EXP‑compatible Extron devices. The first 10 EXP output channels are duplicates of
the 10 analog outputs (except for Downmix Left and Right, which always appear on
EXP outputs 15 and 16). Two additional EXP Outputs are available for 7.1.4 speaker
configurations.
The EXP port is limited to a sample rate of 48 kHz at 24‑bit depth per channel. High
sample rate codecs (such as DTS 96/24 at 96 kHz and Dolby TrueHD at a maximum
192 kHz are first resampled to 48 KHz before transport via the EXP bus.
D
RS-232 port — The SSP200 can be configured with Extron Product Configuration
Software (PCS) or Simple Instruction Set (SIS) commands using this 3‑pole captive
screw connector (see Product Configuration Software starting on page29 and
SIS Configuration and Control starting on page62)
REMOTE RS-232
Tx Rx
RS-232
G
REMOTE
Transmit (Tx)
Receive (Rx)
Ground(Gnd)
RS-232 Device Bidirectional
Transmit (Tx)
Receive (Rx)
Ground(Gnd)
Figure 6. RS-232 Wiring Example
5
6