Mt 880/870/En/Rev. 002/05/98 * 901.882.002
BEISSBARTH MT 870 / MT 880
10 -1
MAINTENANCE AND UPKEEP
Before carrying out any maintenance or servicing work, disconnect the mains plug from the power
supply. If the power supply is permanently attached to the machine, turn off the main switch and
secure it in the off position with a padlock so that it cannot be accidentally switched on again.
If malfunctions occur and the machine operator cannot eliminate them, or if fault indications
are displayed, please consult Beissbarth’s service organisation.
The quality of wheel balancing depends decisively on the condition of the mounting cone at the main
shaft, and the corresponding clamping devices. These parts must therefore be looked after
withg par ticular care. Keep them clean, dry and free from grease when in use.
If the wheel balancing computer is to remain out of use for a lengthy period, it should be covered
over and stored in a dry place. The mounting cone and the clamping devices must be protected
against corrosion by coating them with an acid-free oil. However, this oil film must be removed again
before the machine is next used.
Service
(+49) 89-14 901-233
To Next Page
Loading...
