Mt 880/870/En/Rev. 002/05/98 * 901.882.002
BEISSBARTH MT 870 / MT 880
7-1
BALANCING PROCEDURE
Safety precautions:
In Germany, the wheel guard must be electrically
interlocked with the machine.
It must not be possible to switch the machine on
unless the wheel guard is closed.
(
Note: local regulations may differ and should
be complied with.)
Close the wheel guard; the machine
will start automatically. Alternatively,
close the wheel guard, mark the screen
button Start balancing run with the Action Center
and press to start.
The measuring run lasts approx. 3 seconds, after
which the machine brakes the wheel automati-
cally at precisely the external balancing point.
The amount of imbalance and the adjusting
arrow for the external wheel plane are shown in
green.
Attach the balance weight for the outer plane
according to the chosen balancing method.
Note:
The balancing point at which the weight has to
be attached for both the external and the internal
plane is always in the 12 o’clock position.
When the “STOP” screen button is
activated, the wheel guard is opened
or the main (emergency off) switch is
operated, the balancing run is always interrupted.
To Next Page
Loading...
