Facom BEISSBARTH microtec 880 - Preparatory Work; Clamping the Flange; Clamping Wheel on to Flange

Mt 880/870/En/Rev. 002/05/98 * 901.882.002
BEISSBARTH MT 870 / MT 880
4-1
PREPARATORY WORK
Clamping wheel on to flange
Important:
Dirty or damaged clamping devices or
wheels, incorrect clamping devices (see
table of flanges), excessive or uneven
tightening torques when tightening the
wheel studs at the flange or fitting to
the vehicle can cause balancing errors
of 30 grams or more to occur.
Refer to the flange table for the
most satisfactory means of attaching a
particular wheel.
Clamping the flange
Push the complete flange (of the type suitable for
the wheel) on to the conical shaft and tighten the
retaining screw firmly with the Allen key provided.
(The picture shows a middle-centring flange.)