730
1200
1750
1540
1100
420
700
1350
1650
500
650
Wheel guard
closed
50
Mt 880/870/En/Rev. 002/05/98 * 901.882.002
BEISSBARTH MT 870 / MT 880
2-1
SAFETY PRECAUTIONS AND START-UP
The wheel balancing machine must only be used to balance vehicle wheels and tyres in
conformity with the stated technical data.
Only properly trained and skilled personnel must operate the machine.
Power-driven wheel balancing machines must only be operated with a wheel guard in position
(German law: please conform with local regulations in other countries).
Safety equipment must never be removed or put out of action
Essential repairs must only be performed by servicing personnel familiar with the machine. Any
form of tampering with the machine absolves Beissbarth from all liability for resulting damage.
Before starting work on the electrical system, pull out the mains plug and secure main switch to
prevent it from being turned on accidentally.
Work on the electrical installation must be performed by qualified electrical technicians.
The wheel balancing machine must not be operated in explosion-risk areas.
The wheel balancer must only be used indoors.
Setting up the machine
The machine must be secured to a
firm, flat and vibration-proof concrete
floor, using dowels.
Space required:
Space required:
microtec 880
microtec 880
Before opening
unplug power
supply
Significance
Warning symbol used
Change of machine’s location
Please observe the following instruc-
tions when transporting the machine
to its installation point (or in the event
of further changes in location):
- When transporting the machine in
its original packing use a suitable
fork lift truck which should enter
the lower packing pick-up points
(pallet).
- Keep transport pallet for future
changes of location.
- For machine transport, attach it
with suitable wood screws to the
pallet.
To Next Page
Loading...