Fagor CNC 8058elite T User Manual

Remote modules. RIO5, RIOW and RIOR series.
CNCelite
8058 8060
8065 8070
ꞏ15ꞏ
REF. 2107
Read the following safety measures in order to prevent harming people or damage to this product and those
products connected to it. Fagor Automation shall not be held responsible of any physical or material damage
originated from not complying with these basic safety rules.
PRECAUTIONS BEFORE CLEANING THE UNIT
PRECAUTIONS DURING REPAIRS
In case of a malfunction or failure, disconnect it and call the technical service.
PRECAUTIONS AGAINST PERSONAL HARM
SAFETY CONDITIONS.
Before start-up, verify that the machine that integrates this CNC meets the 2006/42/EC Directive.
Do not get into the inside of the unit. Only personnel authorized by Fagor Automation may access the
interior of this unit.
Do not handle the connectors with the unit
connected to AC power.
Before handling these connectors (I/O, feedback, etc.), make sure
that the unit is not powered.
Do not get into the inside of the unit. Only personnel authorized by Fagor Automation may access the
interior of this unit.
Do not handle the connectors with the unit
connected to AC power.
Before handling these connectors (I/O, feedback, etc.), make sure
that the unit is not powered.
Interconnection of modules. Use the connection cables provided with the unit.
Use proper cables. To prevent risks, only use cables and Sercos fiber recommended for
this unit.
To prevent a risk of electrical shock at the central unit, use the proper
connector (supplied by Fagor); use a three-prong power cable (one
of them being ground).
Avoid electric shocks. To prevent electrical shock and fire risk, do not apply electrical voltage
out of the indicated range.
Ground connection. In order to avoid electrical discharges, connect the ground terminals
of all the modules to the main ground terminal. Also, before
connecting the inputs and outputs of this product, make sure that the
ground connection has been done.
In order to avoid electrical shock, before turning the unit on verify that
the ground connection is properly made.
Do not work in humid environments. In order to avoid electrical discharges, always work with a relative
humidity (non-condensing).
Do not work in explosive environments. In order to avoid risks, harm or damages, do not work in explosive
environments.

Fagor CNC 8058elite T Specifications

General

Brand	Fagor
Model	CNC 8058elite T
Category	Control Unit
Language	English