EasyManuals Logo

Fagor CNC 8058elite T User Manual

Fagor CNC 8058elite T
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
DRAFT DRAFT DRAFT DRAFT DRAFT
DRAFT DRAFT DRAFT DRAFT DRAFT
Remote modules. RIO5, RIOW and RIOR series.
CNCelite
8058 8060
8065 8070
RIOR-E-48I32O / RIOR-E-48I32O-ANALOG (ETHERCAT).
Specifications.
ꞏ104ꞏ
REF. 2107
6.1.1 Conditions of acceptabity for NRTL certification.
This equipment is for indoor use in non-hazardous locations, operated by qualified
personnel skilled in its use.
The equipement shall be supplied with the specified rated voltages according to the
hardware manual.
The nature of the installation where it is connected must not exceed OVC II.
The equipment fullfils the requirements of the tested standars only if it is operated
according to the hardware manual.
The end application has to fulfill the requirements for resistance to mechanical stresses.
To meet IP 54, the system must be installed in an appropiate enclosure according to the
hardware manual.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fagor CNC 8058elite T and is the answer not in the manual?

Fagor CNC 8058elite T Specifications

General IconGeneral
BrandFagor
ModelCNC 8058elite T
CategoryControl Unit
LanguageEnglish

Related product manuals