Fagor CNC 8058elite T User Manual

Remote modules. RIO5, RIOW and RIOR series.
CNCelite
8058 8060
8065 8070
RIO5 REMOTE MODULES. (CANOPEN PROTOCOL).
3.
Numbering of the analog inputs and outputs and of the temperature
sensor inputs.
ꞏ45ꞏ
REF. 2107
3.7 Numbering of the analog inputs and outputs and of the temperature
sensor inputs.
The CNC numbers the modules automatically according to the order of the remote groups
(ꞏADDRESSꞏ selector of the power supply module).
When numbering the analog inputs, the CNC considers the inputs for the temperature sensor
(connector X5) as analog inputs. Therefore, when numbering the inputs, the CNC considers
that each module has 6 analog inputs; the four analog inputs plus the two temperature sensor
inputs.
The CNC machine parameters must be set to indicate the number of PT100 inputs and to
which analog inputs they are connected. A PT100 input is active if it has one of these
temperature sensors connected to it. Refer to the installation manual for further detail.
Group ꞏ1ꞏ
4 analog inputs.
4 analog inputs.
2 PT100 inputs
Example.
Group ꞏ1ꞏ
(address = 1)
Group ꞏ2ꞏ
(address = 2)
Analog inputs.
PT100 inputs.
1 ꞏꞏ 4
5 ꞏꞏ 6
7 ꞏꞏ 10
11 ꞏꞏ 12
Analog outputs. 1 ꞏꞏ 4 5 ꞏꞏ 8
POW ER
ANA LOG I/O
X1
CHS
GN D
24V
SPEED
1
0
ADDRESS
ERR
RUN
CAN
0
1
LT
GN D
L
SH
H
SH
GN D
L
SH
H
SH
X2
X3
01
01
SH
X4
RL1
R1
R1
RF1
SH
X5
12
I1
I1
SH
12
GN D
X6
POW ER
ANA LOG I/O
X1
CHS
GN D
24V
SPEED
1
0
ADDRESS
ERR
RUN
CAN
0
1
LT
GN D
L
SH
H
SH
GN D
L
SH
H
SH
X2
X3
01
01
SH
X4
RL1
R1
R1
RF1
SH
X5
12
I1
I1
SH
12
GN D
X6
Group ꞏ2ꞏ
4 analog inputs.
4 analog inputs.
2 PT100 inputs

Fagor CNC 8058elite T Specifications

General

Brand	Fagor
Model	CNC 8058elite T
Category	Control Unit
Language	English