Fairplay MP-50 - Changing Your Transmitter Settings (G2)

MP-72/52 G2 Wireless Option
MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13 105
 ALL — You can synchronize multiple scoreboards to one control.
Channel Setting
 CH# (0-15) — If Transmission Mode is set to SEL, then the
transmitter broadcasts only at the channel shown. If Transmission
Mode is set to ALL, the transmitter broadcasts only on the ALL
channel.
CHANGING YOUR TRANSMITTER SETTINGS (G2)
1. To change any or all of these three settings, press SHIFT + 9 key.
2. The bottom line of the LCD will display HIPOWER XMIT.
 If you respond YES , the radio will transmit at
HIGH power mode.
 If you respond NO , the radio will transmit at
LOW power mode.
Note: If you want the ALL SCBDS feature to be disabled, there is a switch on
the radio receiver card that controls this. Refer to “Radio Receiver Switch
Setting” in this chapter, or contact the Trans-Lux/Fair-Play Help Desk for
assistance.
3. The prompt ALL SCBDS? Y/N will appear next.
 If you respond YES , the radio will transmit on
ALL scoreboards channel.
 If your response is NO , the radio will transmit
on SEL (select) channel.
4. The final prompt will be SEL. CHANNEL.
 At this prompt, the number shown is the
channel the radio is currently set to.
 If you with to change the channel, enter a one or two-digit number for the
desired channel (00 to 15), then press ENTER .
 To move on to the next setting without changing the select channel, hold
down the SHIFT key and press the NEXT key ( 5 key).
SC 45’ 3:22
HIPOWER XMIT?Y/N
SC 45’ 3:22
ALL SCBDS? Y/N
SC 45’ 3:22
SEL. CHANNEL? _4