Basketball
22 MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
BASKETBALL
If basketball is not the sport currently selected on the MP-70/50, or if you want to
change the controller’s settings for basketball, see SELECTING AND CHANGING
SPORTS on page 151.
You should also verify that the controller has been programmed to use the
correct scoreboard type and data format as instructed in PROGRAMMING THE
SYSTEM SETTINGS on page 142.
SPORT-SPECIFIC SETTINGS FOR BASKETBALL
When you select basketball as instructed on see SELECTING AND CHANGING
SPORTS on page 151, the MP-70/50 presents you with the sport-specific setting
options in the sequence outlined on the following pages. When you adjust these
settings, the MP-70/50 stores your selections in permanent memory. Your
settings become active each time you select basketball in the future.
The sequence shown on the following pages presents you with all of the
options you could encounter while programming sports-specific settings.
However, these options presented to you may vary, depending upon the
type of your control (MP-70 or MP-50), the version number of the
firmware in your control, the two-digit board type that you’ve selected,
and your scoreboard model, or whether your basketball game is taking
place according to FIBA or North American rules. Hence, not all of the
options outlined in this chapter may appear on your control.
As you run through the following programming sequence, and you find
the need to back up to a previous programming option earlier in the
sequence, you can back up by selecting SHIFT + 8 .
You may skip a prompt by pressing the NEXT key. This will advance
you to the next prompt, but will save the existing settings of your current
prompt without making any changes. However, Fair-Play advises that
you respond YES or NO to all prompts, so that you have made all of
the appropriate selections for your sports event.
You may exit the programming sequence at any time by pressing
the ESC key. This will take you to the Quit prompt.
To Next Page
Loading...