MP-73/53 G3 Wireless Option
122 MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
CONNECTING TO THE SCOREBOARD (G3)
1. Turn on scoreboard and the MP-73/53. Wait until they finish with their
start up sequence.
2. Scoreboard is scanning.
a. It displays its assigned group under the home and minutes
digits. The seconds and visitor digits will also display the
channel associated with the group that it is currently scanning.
b. It will scan for a control transmitting in the assigned group.
c. If it does not find its assigned group, then it will scan for the
alternate group.
d. If after two (2) minutes and the scoreboard does not find a
signal, then all the digits are blanked while it continues to scan.
3. Scoreboard finds and locks-on to assigned group or alternate group.
a. When the scoreboard is properly receiving data from the wireless
MP-73/53, it will display the scoring data: time, score, fouls etc.
b. If the scoreboard locks-on to the alternate group, it will check
periodically if its assigned group is transmitting. If it finds its
assigned group, then it will leave it’s alternate group and lock on
instead to its assigned group.
4. If the scoreboard loses the signal, or if the signal is intermittent, the
scoreboard or timer will hold its last transmission for a few seconds and
re-scans. See 2 above.
Note: For additional information refer to VIEWING YOUR G3 TRANSMITTER settings
on page 126 or WIRELESS TROUBLESHOOTING (G3) on page 133.
To Next Page
Loading...
