Segment Timer Operation
166 MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
To decrease one numeric increment of either Break Times or Segment
Times, press -1/BLANK .
To switch from Segment Times to Break Times (or from Break Times to
Segment Times), press +2 .
Note: If you wish to program the Segment Timer to stop at the end of a
sequence, simply enter a time of 00:00 for the stop segment while you are
in Program Mode.
If you make an error while making a time entry, press 0 until the time
shows 00:00 again, and then re-enter the correct time.
When you have entered your correct times for the Segment Timer, exit the
Program Mode for Segment Timer by pressing the SHIFT and ESC keys at
the same time.
When you do so, you will see a question that asks, BLANK COUNTING? If you
select this feature, the clock will not show the Segment
countdown, but you will still be able to watch the
countdown on the MP-70/50’s LCD screen.
Enter 4/YES if you want to blank the counting, so that it does not appear on
the scoreboard. Enter 6/NO if you want the countdown to appear on the
scoreboard.
Next, the LCD screen displays a question that asks,
INCREMENT SEGMENTS#? You have the choice of
either counting segment numbers up or down.
Enter YES if you want to increment (count up) the
segment numbers, and NO if you want to decrement (count down) the
segment numbers.
Last, the LCD screen displays a question that asks, “Seg. (Segment) Timer
Mode?”
Press YES to return to the Segment Timer
operations.
If you press NO , the MP-70/50 returns to the
standard scoreboard timing operations.
Program Segments
Blank Counting?
Program Segments
Inc. Segments#?
Program Segments
Seg.Timer Mode?
To Next Page
Loading...
