DTC1000Me-1250e-4250e-4500e Card Printer Service Manual PLT-01543 rev 1.0
.
Safety Messages (review carefully)
The purpose of this section is to provide the User with specific replacement procedures for the Card Printer.
Please review standard precautions (to take) while performing these replacement procedures.
Critical Instructions for Safety purposes
Failure to follow these installation guidelines can result in death or serious injury.
Information that raises potential safety issues is indicated by a warning symbol (as shown
to the left).
To prevent personal injury, refer to the following safety messages before performing an
operation preceded by this symbol.
To prevent personal injury, always remove the power cord prior to performing repair
procedures, unless otherwise specified.
To prevent personal injury, make sure only authorized service personnel perform these
procedures.
This device is electrostatically sensitive. It can be damaged if exposed to static electricity
discharges.
Information that raises potential electrostatic safety issues is indicated by a warning symbol
(as shown to the left).
To prevent equipment or media damage, refer to the following safety messages before
performing an operation preceded by this symbol.
To prevent equipment or media damage, observe all established Electrostatic Discharge
(ESD) procedures while handling cables in or near the Circuit Board and Printhead
Assemblies
To prevent equipment or media damage, always wear an appropriate personal grounding
device (e.g., a high quality wrist strap grounded to avoid potential damage).
To prevent equipment or media damage, always remove the Ribbon and Cards from the
Printer before making any repairs, unless otherwise specified.
To prevent equipment or media damage, take jewelry off of fingers and hands, as well as
thoroughly clean hands to remove oil and debris before working on the Printer.
To Next Page
Loading...
Need help?
General
